TECHNICAL DATA

Operating Voltages Available:
12/24VDC 15AMP
120 VAC 50/60 HZ 3AMP controller and Motor control models 16Amp to 1HP.
230 VAC European 50/60 HZ 3AMP controller and Motor control models 16Amp to 1HP.

WARRANTY
SEE WATER INC. WARRANTS THAT THE SEE WATER® WATER PUMP SWITCH, WILL BE FREE FROM DEFECTS IN MATERIAL AND WORKMANSHIP FOR A PERIOD BEGINNING AS OF THE DATE OF PURCHASE FOR ONE (1) YEARS. THIS WARRANTY IS LIMITED TO REPLACEMENT OF THE SWITCH ONLY AT THE SOLE DISCRETION OF SEE WATER INC. THIS WARRANTY IS VALID ONLY WHEN THE PRODUCT INSTALLED IS IN STRICT COMPLIANCE WITH THE MANUFACTURE'S INSTALLATION INSTRUCTIONS. SEE WATER INC. WILL REPLACE THE SWITCH WHEN IT IS RETURNED TO SEE WATER INC. WITH BUTT SPLICES ATTACHED TO SWITCH WIRE HARNESS POSTAGE PREPAID WITH PROOF OF ORIGINAL PURCHASE INCLUDED.

WIRING
To prevent corroded wire connections, be sure to use adhesive filled heat shrink wire connections to seal all connections.

Locate wire connections above the highest possible water level. Be sure to use the appropriate wire size from battery source recommended by pump manufacturer.

FUSING
Follow the pump manufacturer's instructions on fusing.

BLACK WIRE - IN
WHITE WIRE + IN
BROWN WIRE + OUT

	Disconnect voltage source.
	Route and secure all wires as high as possible above the water level.
	Connect and crimp the switch positive (+) red wire to the positive (+) source.
	Connect and crimp the switch and pump negative (-) black wire to the negative (-) source.
	Connect and crimp the positive (+) brown wire from switch to positive (+) wire of pump.
	Use heat shrink wire connectors included, or wires will corrode and your warranty will be voided.
	Use heat source to shrink wire connectors until adhesive inside melts and flows out the ends.
	Re-connect the voltage source, hold your hand or metallic object over the sensor area to test pump operation.
	Be sure that the bottom of the switch is aligned above the pump impeller for proper turn-on and turn-off operation. If the switch is installed too low the pump will suck air and continue running until the pump fails.

WIRING
To prevent corroded wire connections, be sure to use adhesive filled heat shrink wire connections to seal all connections.

Locate wire connections above the highest possible water level. Be sure to use the appropriate wire size from battery source recommended by pump manufacturer.

FUSING
Follow the pump manufacturer's instructions on fusing.

BLACK WIRE + IN
WHITE WIRE - IN
BROWN WIRE + OUT

	Disconnect voltage source.
	Route and secure all wires as high as possible above the water level.
	Connect and crimp the switch phase (black) wire to the source.
	Connect and crimp the switch and pump neutral white wire to the source.
	Connect and crimp the load brown wire from switch to phase wire of pump.
	Use heat shrink wire connectors included, or wires will corrode and your warranty will be voided.
	Use heat source to shrink wire connectors until adhesive inside melts and flows out the ends.
	Re-connect the voltage source, hold your hand or metallic object over the sensor area to test pump operation.
	Be sure that the bottom of the switch is aligned above the pump impeller for proper turn-on and turn-off operation. If the switch is installed too low the pump will suck air and continue running until the pump fails.

Click Here to go back to Oil Smart® Water Pump Switch