The Smart Alternative to Float Switches

Eliminates the need of multiple float switches; The SCS Pump Control

provides the means of choosing the pump start and pump stop based

on application characteristics with a single switch. This innovative

control utilizes microprocessor memory to allow the self-calibrating

sensors (SCS) to adapt to any environment.

SCS Sewage Control Features

• Built in "microprocessor-memory" technology to allow for each sensor to recalibrate when needed or every 24 hours to adjust to current environment conditions.
• Two independent sensors; One primary pump on sensor with built-in time delay and self calibration. One backup pump on sensor with built-in time delay and self calibration.
• Type 3R Outdoor approved plastic enclosure
• Heavy-Duty SJTOW water resistant cable
• no moving parts

SCS Pump Switch (8 second time delay)

    16 Amps@120VAC or 8 Amps@230V European

          SCS120P   with piggyback plug, 20' cord 120V

          SCS120     hardwire, 20' cord 120V

          SCS230     hardwire, 20' cord 230V

Custom time delay choices can be programmed upon request.

Operation

When water/wastewater reaches the long (primary) sensor, the sensor will send a signal to turn the pump on and the pump will remain on for an additional 8 seconds after the liquid clears the sensor. The pump start and pump stop time are determined by the programmed time delay. Standard programming for the switch is 8 seconds. However, times can be factory programmed for any time delay or the SCS with adjustable time delays are available. If for some reason, the primary sensor does not activate and the water/wastewater continues to rise to the short sensor, the short (backup) sensor will send a signal to turn the pump on for the same time delay.